Home/Quality

Quality system

For wear parts, quality is whether the fifth order measures the same as the first.

Requirement capture

Part number, drawing, sample or worn part. Machine model, running conditions and the failure that triggered the replacement.

Specification

The measurable set: dimensions, tolerances, material grade, hardness, surface finish, and the interfaces that determine fit.

Production qualification

The line, tooling and process for that specific component — process control, measurement equipment and evidence of repeatability on similar parts.

Sample approval

First article against the specification, with dimensional report. Approved samples are retained as the reference for repeat orders.

Batch inspection

Incoming inspection against the approved sample. Critical dimensions are measured; material certificates are kept where applicable.

Documentation

Packing list, inspection record and material certificates travel with the shipment. Discrepancies are raised before dispatch, not after.

Inspection evidence

  • —Dimensional inspection reports on critical features
  • —Material grade and, where relevant, mill certificates
  • —Hardness and surface condition for contact parts
  • —Approved sample retained per reference
  • —Packing and quantity verification before dispatch

Substitution policy

Mills lose more time to a “close enough” substitution than to a late delivery. If a material or dimension has to change, it is proposed in writing with the reason and the expected effect on wear life — and only shipped after approval.

Where a reference cannot be matched to the original specification, we say so rather than shipping an approximation.

Discuss a specification